JVC MX-KB30 Manuel d'utilisateur télécharger pdf (Page 40)

Getting Started

English

Connecting the AM Antenna

Rear Panel of the Unit

• Even when connecting an outside AM antenna, keep the indoor AM loop connected.

CAUTION:

• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

Connect the right speaker to the RIGHT speaker terminals and the left speaker to the LEFT speaker terminals. “Right” / “Left” is labeled

on the rear of the speaker.

1. Open each of the terminals to connect the speaker wire leads.

2. Connect the speaker cords to the Speaker terminals of the Unit.

Connect the red (+) and black (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the System.

Connect the red (+) and black (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on the System.

3. Close each of the terminals.

CAUTIONS:

• A TV may display irregular colors if located near the speakers. If this happens, set the speakers away

from the TV.

• Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.

AM loop antenna (Supplied)

Turn the loop until you have

the best reception.

Attach the AM loop to its base by

snapping the tabs on the loop into

the slot in the base.

AM antenna wire (not supplied)

If reception is poor, connect the

outside antenna.

Right side (rear view) Left side (rear view)

Black

Red

Black

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 61 62

Pas de commentaire

JVC MX-KB30 Manuel d'utilisateur Page 40