JVC SP-XE5 Manuel d'utilisateur télécharger pdf (Page 3)

– 3 –

Types of speaker systems

JVC

SP-XE5F/SP-XE51F SP-XE5S/SP-XE51S

Front/Center speaker (3) Surround speaker (2)

Connection

1. If cords are covered with insulation, twist the core of the cord at the end

of each cord, then remove the insulation.

2. Insert it into the hole while pressing down the terminal lever.

Observe the tag attached to each cord, and use the appropriate cord

for each speaker.

For SP-XE5F/SP-XE51F

(Rear)

For SP-XE5S/SP-XE51S

(Bottom)

3. Connect to the amplifier.

SP-XE5F/SP-XE51F SP-XE5F/SP-XE51F SP-XE5F/SP-XE51F

CENTER

FRONT

RIGHT

SURROUND

LEFT

SURROUND

RIGHT

FRONT

LEFT

Black ·

Black striped

Red ª

Copper

Black ·

Black striped

Red ª

Copper

Through the hole

Speaker terminals on the amplifier

SP-XE5S/SP-XE51S SP-XE5S/SP-XE51S

ENGLISH

Precautions

Before connecting:

• Make sure to match the polarity (ª and ·) when connecting the

speaker cords.

•Turn off the power to the amplifier before connecting the speaker

system; otherwise, the speakers may be damaged.

• The impedance of each speaker is 6 Ω.

If this does not match with the speaker impedance range indicated on

the amplifier, you cannot connect this system to the amplifier.

• The maximum power handling capacity of the SP-XE5/SP-XE51 is

50 W. Excessive input will result in abnormal noise and possible

damage.

Daily operations and maintenance:

• Be sure to turn down the volume level on the amplifier to prevent

unwanted noise before performing following operations:

–Turning on or off other components

– Operating the amplifier

–Tuning FM stations

–Fast-forwarding a tape

– Continuously reproducing high frequency oscillation or high pitch

electronic sounds

– Connecting or disconnecting a microphone

• When using a microphone, do not aim it at the speakers or use it near

the speakers; otherwise, the howling which occurs may damage the

speakers.

• Before replacing the cartridge, always turn off the power both to the

amplifier and to the turntable; otherwise, the clicking noise may

damage the speakers.

Caution

When installing the satellite speakers on the wall;

• Be sure to have them installed on the wall by a qualified personnel.

DO NOT install the satellite speakers on the wall by yourself to avoid

unexpected damage from their falling off the wall due to incorrect

installation or weakness in wall structure.

• Care must be taken in selecting a location for speaker installation on a

wall. Injury to personnel or damage to equipment may result if the

speakers installed interfere with daily activities.

Speaker for A/V combination

SP-XE5/SP-XE51 has a magnetically-shielded design for placement

adjacent to TVs and monitors without causing color aberrations. However,

color may be affected as a result of how the speaker system is installed.

Therefore, be careful of the following:

1. When placing these speakers near a TV set, turn off the TV’s main

power switch or unplug it before installing the speakers.

Wait at least 30 minutes after the system is installed before turning on

the TV’s power.

2. If another speaker system has been set up near the TV set, that

system may cause color unevenness in the TV’s picture.

3. In spite of the shielded design of these speakers, some types of TVs

may be affected by them. If this happens, move the speakers a short

distance from the TV set.

Specifications

SP-XE5F/SP-XE51F (FRONT/CENTER SPEAKER)

Type : 1-way bass-reflex type

(Magnetically-shielded type)

Speakers : 8 cm cone

Power handling capacity : 50 W

Impedance : 6 Ω

Frequency range : 90 Hz – 20 000 Hz

Sound pressure level : 83 dB/W·m

Dimensions (W × H × D) : 106 mm × 119.5 mm × 102 mm

Mass : 0.64 kg each

Accessories : Speaker cords (4 m) ... 3

SP-XE5S/SP-XE51S (SURROUND SPEAKER)

Type : 1-way bass-reflex type

(Magnetically-shielded type)

Speakers : 8 cm cone

Power handling capacity : 50 W

Impedance : 6 Ω

Frequency range : 80 Hz – 20 000 Hz

Sound pressure level : 76 dB/W·m

Dimensions (W × H × D) : 111.5 mm × 139 mm × 106.5 mm

Mass : 0.52 kg each

Accessories : Speaker cords (10 m) ... 2

Design and specifications subject to change without notice.

02_SP-XE5 2/2/04, 4:43 PM3

1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire

JVC SP-XE5 Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour écrans plats JVC SP-XE5