JVC DT-3D24G1 Manuel d'utilisateur télécharger pdf (Page 6)

Installation

● How to set up 1

You can tilt the monitor as follows.

● Be careful not to pinch your fingers in the gap between the

monitor and the stand.

● When the stand plate is attached to the lower position of the stand

body, you cannot tilt the monitor downward.

● How to set up 2

When the stand plate is attached to the higher position of the stand

body, you can place the monitor as illustrated below.

1 Remove the screws on the sides of the stand (see the following

illustration), and lift up the stand by approximately 148 degrees.

2 Attach the removed screws and place the monitor as illustrated

below.

●

To place the monitor as shown in “How to set up 1” again, remove

the screws on the sides of the stand, align the guidelines, and then

reattach the screws.

Cautions

● When lifting up the stand...

- Lay the monitor on a cloth with the LCD panel facing down to

prevent the LCD panel from being damaged.

Be careful not to pinch your fingers in the moving parts.

● Make sure of lifting the stand up until it stops (Approx. 148°);

otherwise the monitor may fall over.

● Place the monitor on a mat to avoid scratching the table surface.

● Do not lift up the stand when the stand plate is attached to the

lower position of the stand body.

● Do not rest your arm on the monitor or lean against the monitor.

● Do not touch the LCD panel when installing the monitor.

● Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.

Screw (silver)

Approx.

148°

● To detach the stand

Lay the monitor on a cloth with the LCD panel facing down to

prevent the LCD panel from being damaged.

● To install the stand

When attaching the stand to the monitor, insert the guides of

the stand plate into the guide holes on the monitor to place the

stand in the correct position. Then fix the stand firmly with the

attachment screws.

● To adjust the stand height

To change the stand height, detach the stand from the monitor.

Then, change the position of the stand plate according to the

stand height you want by choosing the screw holes to use.

When the monitor is not tilted

(0°), the guidelines align as

illustrated below.

Guidelines

Stand

Monitor

Approx. 6°

0°

Approx. 6°

Attachment screws

Screw holes for stand

attachment

Stand body

Monitor

Screw holes for stand

attachment

Guides

Guide holes

Stand plate

Stand body

Stand

plate

Screw holes

for lower position

Screw holes

for higher position

DT3D24G1_EN.indb 6DT3D24G1_EN.indb 6 11.1.25 0:53:44 PM11.1.25 0:53:44 PM

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

JVC DT-3D24G1 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Affichages publics JVC DT-3D24G1