Jvc VS-DT8 Manuel d'utilisateur Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
16
Using the Tuner
Presetting Stations
(Using the Remote Control)
You can preset up to 30 FM stations and up to 15 AM sta-
tions.
Preset numbers may have been set to factory test fre-
quencies prior to shipment. This is not a malfunction. You
can preset the stations you want into memory by following
one of the presetting methods below.
Manual Presetting
1
Select a band by pressing the FM/AM
button.
2
Press the
4
or
¢
( or ) button to
tune in a station.
3
Press the SET button.
SET will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in step 2 after 5
seconds, press the SET button again.
4
Press the > or < button within 5 seconds
to select the preset number.
> or < button: Increase or decrease the preset
number by 1.
Pressing and holding the button
will rapidly increase or decrease
the preset number.
5
Press the SET button within 5 seconds.
STORED appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
6
Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
preset number.
To change the preset stations,
repeat the same
steps as above.
CAUTION:
Even if the system is unplugged or if the
power failure occurs, the preset stations
will be stored for about 24 hours. However,
in case the preset stations are erased, you
will need to preset the stations again.
To Change the FM Reception
Mode
(Using the Remote Control)
When you are tuned into an FM stereo broadcast, the
STEREO indicator lights up and you can hear stereo ef-
fects.
If an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you
lose stereo effect.
Press the FM MODE button on the Remote Control
so that the MONO indicator lights up on the dis-
play.
To restore the stereo effect,
press the FM MODE button
on the Remote Control so that the MONO indicator goes off.
SET STORED
SETSET
FM/AM
When changing the
Band
FM = 30, AM = 15
or
MONO
FM MODE
VS-DT6-8(J)_EN.book Page 16 Monday, January 21, 2002 5:05 PM
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Commentaires sur ces manuels

Pas de commentaire