JVC RX-DP20VSL Manuel d'utilisateur télécharger pdf (Page 11)

AM (MW/LW) Antenna Connections

Connecting the Speakers

For full enjoyment of the THX modes (see page 45), it is

recommended to use THX-certified speakers.

You can connect the following speakers:

• Two pairs of front speakers to produce normal stereo sound.

• One pair of surround speakers to produce a three-dimensional

sound movement and environmental background-effect sounds.

• One or one pair of surround back speakers to enjoy 6.1-channel or

7.1-channel sound reproduction. A pair of the speakers is required

to use THX Ultra2 Cinema and THX Music modes.

• One center speaker to produce a rich sound image by stabilizing

the sound localization (also used to emphasize human voices).

• One powered subwoofer to enhance the bass and to reproduce the

LFE channel recorded in multi-channel software.

For each speaker (except for a subwoofer), connect the (+) and (–)

terminals on the rear panel to the (+) and (–) terminals marked on

the speakers. For connecting a subwoofer, see page 10.

CAUTIONS:

Use only the speakers of the SPEAKER IMPEDANCE indicated by

the speaker terminals.

• When connecting to both of the FRONT 1 and FRONT 2

SPEAKERS terminals, use speakers with an impedance of

8 Ω to 16 Ω.

• When connecting to either the FRONT 1 or FRONT 2

SPEAKERS terminals, use speakers with an impedance of

4 Ω to 16 Ω.

Basic connecting procedure

1 Cut, twist, and remove the insulation at the end of

each speaker signal cable (not supplied).

2 Turn the knob counterclockwise.

3 Insert the speaker signal cable.

4 Turn the knob clockwise.

Continued on the next page.

Outdoor single vinyl-covered wire (not supplied)

Turn the loop until you

have the best reception.

Notes:

• If the AM (MW/LW) loop antenna wire is covered with

vinyl, remove the vinyl by twisting it as shown in the

diagram.

• Make sure the antenna conductors do not touch any

other terminals, connecting cords and power cord. This could

cause poor reception.

• If reception is poor, connect an outdoor single vinyl-covered wire to

the AM EXT terminal. Keep the AM (MW/LW) loop antenna

connected.

Rear view

FM 75

COAXIAL

ANTENNA

EXT

LOOP

AM (MW/LW) Loop

Antenna (supplied)

Snap the tabs on the loop into the

slots of the base to assemble the

AM (MW/LW) loop.

EN01-17_RX-DP20VSL[B]f.pm5 03.5.21, 17:238

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 77 78

Commentaires sur ces manuels

Pas de commentaire

JVC RX-DP20VSL Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs AV JVC RX-DP20VSL