Jvc KD-LX330R Manuel d'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
10
ENGLISH
Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1).
1 Press SOURCE to
select FM as the source.
2 Press and hold MODE
BAND repeatedly to
select the FM1 band.
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
Press ¢ to tune into
stations of higher frequencies.
Press 4 to tune into
stations of lower frequencies.
BAND
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
A previously preset station is erased when a new station
is stored in the same preset number.
Preset stations are erased when the power supply to the
memory circuit is interrupted (for example, during battery
replacement). If this occurs, preset the stations again.
Tuning into a preset station
You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see
Storing stations in
memory
on pages 9 and 10.
1
Select the band.
1 Press SOURCE to select
FM or AM as the source.
2 If necessary, press and
hold MODE BAND to
select the FM band
number (FM1, FM2 or
FM3).
Each time you press and hold the button,
the FM band changes as follows:
2
Select the number (1 – 6) for the preset
station you want.
If the sound quality decreases and the
stereo effect is lost while listening to an
FM station
In some areas, adjacent stations may interfere
with each other. If this interference occurs, this
unit can automatically reduce this interference
noise (the initial setting when shipped from the
factory). However, in this case, the sound
quality will be degraded and the stereo effect
will be also lost.
If you do not want to degrade the sound quality
and to lose the stereo effect, rather than to
eliminate the interference noise, see “To
change the FM tuner selectivity
IF FILTER”
on page 26.
FM1 FM2 FM3
BAND
Band number and “MEMO” appear
alternately for a while.
EN07-10.KD-LX330R[E]f 2/5/01, 10:14 AM10
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire