JVC FS-L30 Manuel d'utilisateur télécharger pdf (Page 20)

– 17 –

English

Recording

Recording on a Tape

On the unit ONLY:

Put a recordable cassette in with the exposed

part of the tape down.

Close the cassette holder gently and check the

recording direction for the tape.

• If the tape direction is not correct, press TAPE 2 3

twice then 7 to change the tape direction.

• If you want to record on both sides of a tape, see “To

record on both sides—Reverse Mode.”

Start playing the source—FM, AM or

auxiliary equipment connected to AUX jacks.

• When the source is CD, see “CD Direct Recording” on

page 18.

Press REC (recording).

The REC (recording) indicator lights up on

the display and recording starts.

To stop recording, press 7.

The tape stops after 4 seconds.

To remove the cassette, press 0 PUSH OPEN on the unit.

To record on both sides—Reverse Mode

Press REV.MODE (reverse mode) until the

indicator is lit.

• When using the Reverse Mode for recording,

start recording in the forward (3) direction

first. Otherwise, recording will stop when

recording is done only on one side (reverse)

of the tape.

IMPORTANT:

• It should be noted that it may be unlawful to re-record

pre-recorded tapes, records, or discs without the

consent of the owner of copyright in the sound or video

recording, broadcast or cable programme and in any

literary, dramatic, musical, or artistic embodied

therein.

• The recording level is automatically set correctly, so it is

not affected by the other sound settings. Thus, during

recording you can adjust the sound you are actually

listening to without affecting the recording level.

• If recordings you have made have excessive noise or static,

the unit may be too close to a TV. Increase the distance

between the TV and the unit.

• You can use type I tape for recording.

To protect your recording

Cassettes have two small tabs

on the back to protect from

unexpected erasure or re-

recording.

To protect your recording,

remove these tabs.

To re-record on a protected tape, cover the holes with

adhesive tape.

To keep the best recording and playback sound quality

If the heads, capstans, and pinch rollers of the cassette decks

become dirty, the following will occur:

• Impaired sound quality

• Discontinuous sound

• Fading

• Incomplete erasure

• Difficulty in recording

To clean the heads, capstans, and pinch rollers

Use a cotton swab moistened with alcohol.

To demagnetize the heads

Turn off the unit, and use a head demagnetizer (available at

electronics and audio shops).

At the start and end of cassette tapes

There is leader tape which cannot be recorded onto. Thus, when

recording CDs or radio broadcasts, wind the leader tape first to

ensure that the recording will be made without any music part lost.

Heads

Capstans

Pinch Rollers

REC

REV.MODE

REV. MODE

EN17-22_FS-L30[C]f 02.2.13, 3:48 PM17

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

JVC FS-L30 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de CD JVC FS-L30